STANDARD EQUIPMENT:
¨ Power Draw Bar
¨ 3- Axis Newall DP-700 DRO
¨ X –axis Powerfeed
¨ Front & Rear Rubber Way Cover
¨ One Shot Lube System
DVS Head wired 220V (440V requires additional Transformer)
¨ Tool Kit:
Machine Manual, Half-Nut Wrench, Wrench 17m, 19m, Set of 6 Allen Wrenches, Philip
Screw Driver, Flat Head, Screw Driver, Oil Can, Grease Gun, Rear Way Cover Bracket, Pin For Indicator, and Can of Paint.
FEATURES:
¨ Harden & Ground & Chromed Box ways on Column & Knee for Maximum Rigidity
¨ 3 HP Motor
¨ R-8 Spindle
¨ Knuckle joint using bolts & circular T-slot design; Allowing head to swivel left & right, up & down
¨ Dual fan head cooling System
¨ Double Nut Backlash Eliminator
¨ Internal Lubricated Vari-Disc Design
¨ Motor shaft end supported by bearing cap
440V Application needs an optional transformer
SPECIFICATIONS:
TABLE | |
Working surface | 10”x 50" |
T-slot number, size | 3, 5/8" |
CAPACITY | |
Table travel (X-axis) | 35" |
Saddle travel (Y-axis) | 16.3" |
Ram travel | 18.5" |
Quill travel (Z-axis) | 5" |
Knee travel | 15.3" |
Throat distance (min-max) | 9.8” - 28.3" |
Spindle gage line to table top | 1.6”- 16.9" |
SPINDLE | |
Motor | 3 HP |
Wiring voltage | 220V / 440V, 3 Ph, 60 Hz |
Taper | R-8 |
Speed (vari-speed) | 60-4,500 RPM |
Quill feed (IPR) | 0.0015, 0.003, and 0.005 |
Spindle Accuracy | 0.0002" TIR |
Head tilt; right to left (each way) | 90º |
Head tilt; up-and-down (each way) | 45º |
DIMENSIONS AND WEIGHT | |
Floor area (w x d) | 70" x 75"' |
Height | 88" |
Net weight (lbs; approximately) | 3,000 |